Stain Remover

Catalogue

Home > Catalogue > BioGuard Products > Cleaners > Stain Remover

Stain Remover

This is BioGuard's newest, most powerful stain remover. It removes metal and mineral stains including copper, iron, and manganese from all pool surfaces.

• Blend of three different stain removers makes this product multi-functional and versatile
• Can be used for spot treatment
• Can be used on all types of pool surfaces
• Granular product is compatible with biguanide systems such as SoftSwim

Directions For Use:
Stain removal is a multi-step process, which will require several days to complete. Stain Remover is most effective at removing and preventing the reoccurrence of stains when used with Pool Magnet Plus and Sparkle Up filter aid. DO NOT USE STAIN REMOVER ON ACRYLIC SPA SURFACES. DO NOT ALLOW SWIMMING IN THE POOL DURING THIS PROCESS.

1. Adjust balance of pool water to the following: pH 7.0-7.4, total alkalinity 125 - 150 ppm; calcium hardness less than 400 ppm.

2. Adjust chlorine or bromine residual to less than 1.0 ppm. Use Chem-Out if neccessary to reduce the residual of chlorine or bromine. FOR THE NEXT 36 HOURS, the quantity of sanitizer added should be reduced to maintain a chlorine or bromine residual of less than 1.0 ppm.

3. Determine the appropriate dosage for your pool volume and stain condition:

	5,000 gal.	10,000 gal.	15,000 gal.	20,000 gal.	25,000 gal.
Mild and recently acquired stains	.75 lb.	1.25 lb.	2 lb.	2.5 lb.	3.25 lb.
Severe stains or stains present for more than 1 week	1 lb.	2 lb.	3 lb.	4 lb.	5 lb.

4. Determine the appropriate dosage of Pool Magnet Plus for your pool volume. The application rate is 1 quart per 10,000 gallons.

5. Wearing gloves and safety glasses/goggles, predissolve Stain Remover by adding this product to water in a clean plastic pail. Always add product to water. Never add water to the product. Use approximately 4 gallons of water for each pound of this product. Use a plastic or wooden utensil to stir the mixture.

6. With the circulation pump running, pour the mixture into pool water around the edges of the pool.

7. Allow the pool water to circulate for 1 hour. Then apply the proper dosage of Pool Magnet Plus per label directions.

8. Allow pool water to circulate for 4 to 8 hours.

9. Apply Sparkle Up to filter per label directions and your filter type and size.

10. Continue to circulate the pool for an additional 24 hours.

11. Remove Sparkle Up from filter by backwashing or removing grids or cartridge.

12. Test pool water and adjust water balance items and sanitizer to the following: pH 7.4-7.6; total alkalinity 125-150 ppm; chlorine or bromine to residual specified on your sanitizer product.

DO NOT APPLY A SHOCK PRODUCT TO THE POOL WATER FOR 4 DAYS FOLLOWING COMPLETION OF STEP 12

2 lbs.

Click to enlarge