Super Soluble

• 97% active ingredient
• 57% Stabilizer
• pH of 6.0
• Instantly soluble
• Replenishes Stabilizer levels
• Will not significantly lower pH

Directions For Use:
  Backwash the filter system following manufacturer's directions.  Adjust pH levels to between 7.2-7.6.  Add stabilizer to establish a minimum stabilizer level of 30-40 ppm to reduce the degradative effects of sunlight upon the chlorine residual.  Check for metals.  Before using this product, add stain and scale inhibitor to prevent staining of pool surface due to metals.

  With the pump running, broadcast 4 ounces of this product per 10,000 gallons directly into the water in the deep end of the pool as an initial treatment.  Repeat additions until a residual of 1-3 ppm chlorine is established as determined by the use of a test kit or test strips.  To prevent damage to pool surface, use a pool brush to disperse granules that may have settled to the bottom of the pool.  NEVER ALLOW UNDISSOLVED PRODUCT TO REST IN CONTACT WITH BLEACHABLE POOL SURFACES.  Regular use of a test kit or test strips is necessary to determine when it is necessary to add another dose of this product to maintain a residual of 1-3 ppm available chlorine in the pool water.

Superchlorination:
  Broadcast 1 pound of this product per 10,000 gallons directly into the water in the deep end of the pool.  To prevent damage to pool surface, use a pool brush to disperse any granules that may have settled to the bottom of the pool.  NEVER ALLOW UNDISSOLVED PRODUCT TO REST IN CONTACT WITH BLEACHABLE POOL SURFACES.  In water temperatures less than 70˚F, or as an alternate application procedure, predissolve this product prior to applying evenly to the deep end of the pool.  Dissolve this product outdoors, in a clean plastic bucket stirring with a clean plastic or wooden spoon.  Add this product to water; NEVER add water to product.  NEVER add more than 1 pound of this product to less than 3 gallons of cool water.  Do not mix with other products when predissolving.